Click here to return to the EasyGates homepage   Tel: 08450 54 50 70
Electric Gates Automatic Garage Door Openers Access Control Systems Wrought Iron Gates and Railings Help and Support Contact Us
Programming BFT remote controls and receives. BFT simplified receiver programming instructions ( clonix and Intric )
 
Press SW1 or SW2 depending on which channel you wish to program.
Press the secret button on transmitter to be programmed.
Press the 1st or 2nd transmitter button.
To add more transmitters repeat steps 2 and 3 within 10secs.
Wait 10 - 15 sec's to exit program mode.
  Clonix and Intric Receiver boards  

If after the initial programming as above the "jumper" JP5 (Intric) or JP4(Clonix) is removed or opened then subsequent transmitters can be added without accessing the receiver as follows:

Adjacent to the receiver enclosure take a transmitter which has been programmed as above.

  1. Press the secret button.
  2. Press the button that you are going to program
  3. Carry out the next step within 10 seconds
  4. Take the new transmitter
  5. Press the secret button
  6. Press the button to be programmed (as in step 2)
  7. Repeat steps 4-6 for additional transmitters
  8. Wait 30 Seconds to exit programming

The above can only be carried out with one of the original programmed transmitters i.e. not with one that has been "cloned" as above.

  Help and Support    
  Main Page   BFT Remote Controls
  EasyGates Help Forum    
      BFT Gate Automation
  Contact us    
  Main Contact Page    
  <<< Easygates Home Page   Access Control Systems - Main Page
 

 

Terms & Conditions